The ratio of the maximum deflections of a simply supported beam with a central load W and of a cantilever of same length and with a load W at its free end, is

Team MCQ Buddy • 10.52K Points
Tutor II

Q. The ratio of the maximum deflections of a simply supported beam with a central load W and of a cantilever of same length and with a load W at its free end, is

(A) 1/8

(B) 1/10

(D) 1/16

Correct : Option (D)

Discusssion

Be the first to start discuss.

Q. Pick up the correct statement applicable to plate load test

Q. In which of the following type of runners the velocity of whirl at inlet is greater than the blade velocity?

Q. What is standard capacity of hand operated scotch derric crane? (in tones)

Q. Which one of the following statements about the percentage of tensile steel required to produce a balanced reinforced concrete section is correct ?

Q. Which one of these is used as air entraining agent in concrete?

Q. The advantage of nozzle governing is that no regulating pressure is applied.

Q. A staff reading taken on a bench mark or a point of known elevation is called ?

Q. End bearing piles are used ?

Q. If the horizontal cross-sectional area of a wall is 1200 cm², then the basic stress shall be multiplied by a reduction factor equal to

Q. The ratio of the maximum deflections of a simply supported beam with a central load W and of a cantilever of same length and with a load W at its free end, is

Discusssion

Related MCQs