R

Ram Sharma • 193.86K Points
Coach 

Q. In a shell and tube heat exchanger, the height of 25 percent cut baffles is equal to (where, D = inside diameter of shell)

(A) 0.25 D
(B) 0.50 D
(C) 0.75 D
(D) None of these
Correct : Option (C)

Share

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. Heat transfer co-efficient equation for forced convection, Nu = 0.023 Re0.8 . Prn, is not valid, if the value of

Q. The process of heating the cold pressed metallic powder is called __________ in powder metallurgy.

Q. Melt spinning of polymers involves the forcing of polymer melt through spinnerettes (fine holes) into an atmosphere kept at a temperature lower than t

Q. Most chemical plants use an initial working capital amounting to 10-20% of the total capital investment. But this percentage may increase to _________

Q. Dew point of an air-water vapor mixture

Q. A copolymer is formed by the combination of two or more monomer molecules

Q. The addition of antimony in tin-based alloys improves its

Q. The high expansion metal normally used in the bimetallic thermometer is __________ temperature measurement.

Q. Metallic recuperators are not used for waste heat recovery, if the hot flue gas temperature is above __________ °C, because corrosion prevails at hig

Q. A controller action in which there is a con-tinous relation between the values of controlled variable and the rate of change of conrolled output signa