A differentiator is usually not a part of a control system because it

Home / Engineering / Control Systems / Question

V

Vinay Kumar • 8.55K Points
Tutor III

Q.) A differentiator is usually not a part of a control system because it

(A) reduces damping

(B) reduces the gain margin

(C) increases input noise

(D) increases error

Correct answer : Option (C) - increases input noise

Share

Discusssion

Login to discuss.

Related MCQs on Control Systems

Q. In thermal-electrical analogy charge is considered analogous to

Q. Calculate the useful power developed by a motor using the given data: P = 3000 W, I = 60 A, R = .4 Ω. Assume frictional losses are 200 W and windage losses are 400 W.

Q. Low is the G/T ratio of an antenna, higher is its efficiency.

Q. A closed switch has a resistance of

Q. Which among the following constitute the state model of a system in addition to state equations?

Q. If voltage feedback (negative) is applied to an amplifier, its output impedance _________.

Q. In conventional amplifiers, a flat gain response is achieved at the cost of reduced gain. But this drawback can be overcome by using:

Q. The beam width of the antenna pattern measured at half power points is called:

Q. Which of the following components of a D.C, generator plays vital role for providing direct current of a D.C. generator ?

Q. A cumulatively compounded long shunt generator when operating as a motor would be