V

Vinay Kumar • 8.55K Points
Tutor III 

Q. Due to which of the following reasons excessive bond width in control systems should be avoided?

(A) It leads to slow speed of response
(B) It leads to low relative stability
(C) Noise is proportional to band width
(D) None of the above
Correct : Option (C)

Share

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. A separately excited generator as compared to a self-excited generator

Q. The resistance of armature winding depends on

Q. In case of type-1 system steady state acceleration is

Q. An OPAMP has a slew rate of 5 V/μ S .The largest sine wave O/P voltage possible at a frequency of 1MHZ is

Q. In closed loop control system, with positive value of feedback gain the overall gain of the system will

Q. The efficiency of diesel locomotives is nearly

Q. Amplifier efficiency is the ratio of RF output power to DC input power. This parameter determines the performance of an amplifier.

Q. Which of the following protects a cable against mechanical injury ?

Q. Based on the size of the loops, loop antennas are classified as small and large loops. This is the only classification of loop antenna.

Q. A common-collector transistor circuit is often used