V

Vinay Kumar • 8.55K Points
Tutor III 

Q. In an open loop control system

(A) Output is independent of control input
(B) Output is dependent on control input
(C) Only system parameters have effect on the control output
(D) None of the above
Correct : Option (A)

Share

Discusssion

Login to discuss.

Loading Comments....

Related MCQs

Q. amplifiers are linear circuits, where the transistor is biased to conduct over the entire range of the input signal cycle.

Q. Expression for noise of a two port network considering the noise due to transmission line and other lossy components is:

Q. In control system excessive bandwidth is not employed because

Q. are used in the final stages of radar and radio transmitters to increase the radiated power level.

Q. Specific energy consumption is affected by which of the following factors ?

Q. If resistance is 20 Q. and inductance is 27 in a R-L series circuit, then time constant of this circuit will be

Q. Wound rotor and squirrel-cage motors with high slip which develop maximum torque at stand still are used for

Q. Lens antennas are classified into two types. One being fast antenna, the other one is:

Q. Bandwidth of balanced amplifier can be an octave or more, but is limited by the bandwidth of the coupler.

Q. In a cable the voltage stress is maximum at