Home / Engineering / Electrical and Electronics Engineering / Question

M

Mr. Dubey • 51.43K Points
Coach 

Q.) The basic requirement of a dc armature winding is that it must be

(A) a closed one
(B) a lap winding
(C) a wave winding
(D) either b or c
Correct answer : Option (A) - a closed one

Share

Previous

Next

Discusssion

Login to discuss.

Related MCQs on Electrical and Electronics Engineering

Q. The form coefficient of a spring is

Q. When a close coiled helical spring is compressed, its wire is subjected to

Q. The instruction that pushes the general purpose registers, pointer and index registers on to the stack is

Q. According to ASME Section VIII, a linear indication is defined as an indication in which the length is equal to or greater than the width by a factor of:

Q. The satisfactory method of reclaiming worn out and under sized part subject to fatigue loads is

Q. Calorific value of Indian coal is

Q. Coefficient of discharge is the ____________

Q. The ISOLINES system variable specifies

Q. Machining allowance does not depend on which of the following factor?

Q. Most commonly used lubrication system in automobiles is the