M

Mr. Dubey • 52.33K Points
Coach 

Q. For extinguishing electrical fires

(A) Carbondioxide fire extinguisher should be used
(B) Rubber pieces should be thrown
(C) Water should be sprinkled
(D) Carbon tetrachloride fire extinguisher should be used

Share

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. The selection of material for gears depends on

Q. PERT analysis is based on

Q. As viscosity of lubricating oil decreases, bearing load capacity

Q. Fouling factor for a heat exchanger is given by (where, U1 = heat transfer co-efficient of dirty surface U2 = heat transfer co-efficient of clean surf

Q. Which standard is fixed and used forindustrial laboratories?

Q. Excessive moisture in steam in a steam turbine is likely to result in

Q. In case of four cylinder in line engine, the number of firing stroke (s) in one revolution of crank is

Q. Colburn analogy is applicable for the value of Prandtl number from

Q. Machining allowance does not depend on which of the following factor?

Q. Tangential stretch forming and simple stretch forming are quite similar to each other.

Question analytics