M

Mr. Dubey • 53.43K Points
Coach 

Q. The bundling of conductors is done primarily to

(A) reduce reactance
(B) increase reactance
(C) increase radio interference
(D) reduce radio interference
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. The rolling contact bearings as compared to sliding contact bearings have

Q. Which of the following is a part of reciprocating steam engine and not a part of steam turbine plant?

Q. Which of the following welding discontinuities would be considered the most serious?

Q. For crank shaft bearings, the ratio of the length of the journal to its diameter is _________.

Q. Absorption factor is defined as (where, S1 = slope of the operating line S2 = slope of the equilibrium curve)

Q. Which of the following defects occur due to the entrapment of gas bubbles by the freezing dendrites during the cooling of molten pad?

Q. Metals approach superconductivity condition

Q. The rate of emission of radiation by a body does not depend upon the

Q. The first TdS equation is

Q. The overall heat transfer co-efficient for a shell and tube heat exchanger for clean surfaces is U0 = 400 W/m2.K. The fouling factor after one year of

Question analytics