R

Ram Sharma • 193.86K Points
Coach 

Q. High speed cutting tool steels contain about __________ percent of tungsten.

(A) 6-8
(B) 18-20
(C) 30-35
(D) 50-55
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. Ammonium phosphate is a _________ fertiliser.

Q. Maximum heat transfer in high temperature furnaces is by

Q. In shell and tube heat exchangers, straight tie rods are used to

Q. jH factor for heat transfer depends upon the __________ number.

Q. Which of the following is not applicable to fluidised bed combustion of coal?

Q. A proportional controller with a gain of Kc is used to control a first order process. The offset will increase, if

Q. An annuity is a series of equal payments occuring at equal time intervals, and this amount includes the sum of all payments plus interest, if allowed

Q. Incomplete combustion of fuel in the furnace is judged by high __________ of the flue gases.

Q. The heat transfer by radiation from a mild steel surface is to be reduced by reducing the emissivity of the surface. This can be best achieved by

Q. Boiler feed water pump is usually a __________ pump.

Question analytics