M

Mr. Dubey • 53.48K Points
Coach 

Q. Which process is used primarily to obtain surface finish

(A) Swaging
(B) Electroforming
(C) Shining
(D) Parkerizing
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. If the spring is compressed completely and the adjacent coils touch each other,the the length of spring is called as?

Q. The technology life cycle concerned with the time and cost of developing the technology

Q. For the maximum range of a projectile the angle of projection should be

Q. Steel balls for ball bearings are generally made of

Q. Loss of engine compression can result from

Q. An advantage of a gamma ray source is:

Q. According to Unwin's formula, the relation between the diameter of rivet hole (d) and the thickness of plate (t) is given by (where d and t are in mm)

Q. is the additional flow occurring during rainy season.

Q. Carbondioxide has all the following properties EXCEPT that it is

Q. Crushing resistance required to crush the rivet per pitch length is

Question analytics