M

Mr. Dubey • 52.30K Points
Coach 

Q. one of the following is main purpose of Normalizing

(A) to improve machinability
(B) to modify and refine grain
(C) to homogenize the microstructure
(D) all of the above
Correct : Option (D)

Share

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. The most frequent method of bacterial reproduction is by

Q. Solder is an alloy consisting of

Q. Which type of gamma ray source would be used to radiograph a weld in 150 mm thick steel plate?

Q. Heat transfer co-efficient equation for forced convection, Nu = 0.023 Re 0.8. Prn, is not valid, if the value of

Q. motor. The maximum allowable current is 55 A and the minimum current is about 35 A. The armature resistance of the motor is 0.4 Ω. What will be the

Q. Which of the following uses a number of two-dimensional profiles for generating a three-dimensional object?

Q. The power developed in four stroke I.C. engine, for the same engine speed and cylinder volume, as compared to that of a two stroke engine is

Q. Based upon the nature of heat exchange process, the heat exchangers are classified into how many categories

Q. The speed of dc motor is highest on

Q. What is used for measuring offsets, but it is often used by building surveyors or architects?