M

Mr. Dubey • 52.63K Points
Coach 

Q. In normalizing, one of the following is not correct

(A) it relieves internal stresses
(B) it produces a uniform structure
(C) the rate of cooling is rapid
(D) the rate of cooling is slow
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. Which of the following is not Solid-based RP system?

Q. In a steam engine, the earlier cut-off with a simple slide valve may be obtained by increasing the steam lap and the angle of advance of the eccentric

Q. Which of the following short-circuit is the most dangerous?

Q. Exhaust gas leakage into the cooling system is most likely be due to defective

Q. In Opitz system, 2nd digit indicates

Q. If the temperature of a solid surface changes from 27°C to 627°C, then its emissive power changes in the ratio of

Q. Which one of the following is a safety device on a compressor?

Q. What is the effect of reheat pressure on mean temperature of heat addition Tml?

Q. Which of the following is the direct measure of surface finish in Wallace surface dynamometer?

Q. In helical gears, the distance parallel to the axis, between similar faces of adjacent teeth, is called

Question analytics