R

Ram Sharma • 193.86K Points
Coach 

Q. Which of the following is not fixed by the process requirements, in the design of absorbers?

(A) Flow rate of the entering gas
(B) Composition of the entering liquid
(C) Terminal concentrations of gas stream
(D) None of these
  • Correct Answer - Option(D)
  • Views: 525
  • Filed under category Mass Transfer
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. ________ has a negative co-efficient of linear expansion.

Q. A magnetic flowmeter is

Q. The mass transfer co-efficient for a solid sphere of radius 'a' dissolving in a large volume of quiescent liquid, in which D is the diffusivity of sol

Q. Detergent is added as an additive in engine lubricating oil to

Q. Bomb calorimeter is used to determine the (where, GCV - Gross Calorific Value. NCV - Net Calorific Value.)

Q. Nominal and effective interest rates are equal, when the interest is compounded

Q. An increase in the liquid resistance to interphase mass transfer and a resultant reduction in plate efficiency is caused by

Q. Coal is pulverised before burning in large capacity boiler furnaces mainly to

Q. A mixture of 10% C6H6 vapour in air at 25°C and 750 mm Hg has a dew point of 20°C. Its dew point at 30°C and 700 mm Hg will b

Q. Temperature of a furnace fired with low calorific value fuel gas (i.e. lean gas) can be increased by

Question analytics