M

Mr. Dubey • 52.43K Points
Coach 

Q. In flow through pipe bends the pressures on inner and out radii

(A) Stand at the same level increasing gradually towards the pipe center.
(B) Vary, it being more on the inner core.
(C) Are different, pressure increases with increase in radius and is, therefore, more at the outer radius.
(D) Do not vary and are the same as at the center of the pipe.
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. A channel is said to be of most economical cross-section, if

Q. The discharge of a depressed nappe is 6 to 7 percent __________ that of a free nappe.

Q. In Working Stress Method, which of the following relation is correct?

Q. The equation = C + is given by

Q. The specific speed of a centrifugal pump may be defined as the speed of an imaginary pump, identical with the given pump, which will discharge one lit

Q. The hydraulic efficiency of an impulse turbine is maximum when velocity of wheel is

Q. Deaeration of high pressure boiler feed water is done to reduce

Q. An aggregate which passes through 25 mm I.S. sieve and is retained on 20 mm sieve, is said to be flaky if its least dimension is less than

Q. Pitot tube is consists of a glass tube bent through

Q. A fillet weld whose axis is parallel to the direction of the applied load, is known as

Question analytics