N

Nisha Gupta • 2.32K Points
Master 

Q. Copper brushes in D.C. machine are used

(A) where low voltage and high currents are involved
(B) where high voltage and small cur-rents are involved
(C) in both of the above cases
(D) in none of the above cases
Correct : Option (A)

Share

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. The diameter of the rotor shaft for an electric motor depends on which of the following ?

Q. The resistance encountered by a train in motion is on account of

Q. In a diode frequency multiplier, an input signal of frequency fo applied to the diode is terminated with at all frequencies other th

Q. In lap winding, the number of brushes is always

Q. Hartley oscillator has inductance values of 12 mH and 4 mH in the feedback section and a capacitor of 4 nF. Then the resonant frequency of the circuit

Q. Lens antennas are classified into two types. One being fast antenna, the other one is:

Q. In all base driver amplifiers

Q. Aliasing is caused when:

Q. Which of the following device should be used as a switch in a low power switched mode power supply (SMPS)?

Q. Two generators A and B have 6-poles each. Generator A has wave wound armature while generator B has lap wound armature. The ratio of the induced e.m.f