M

Mr. Dubey • 52.30K Points
Coach 

Q. 'Fouling factor' used in the design of a multipass shell and tube heat exchanger is a www.objectivebooks.com

(A) Non-dimensional factor
(B) Factor of safety
(C) Conversion factor for individual film heat transfer co-efficient to overall heat transfer coefficient
(D) None of these
Correct : Option (B)

Share

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. The amplitude of vibration is always __________ the radius of the circle.

Q. The firing order in case of four cylinder in-line engines is uaually

Q. Temperature profile in steady state heat transfer is

Q. A rack is a gear

Q. Statement 1: In the process of making certain oils, nickel is added as a catalyst. Statement 2: Nickel is injurious for consumption.

Q. Steam distillation is used to

Q. In the above problem, acceleration of crooshead at 30o phase equals

Q. Car speed of a lift is usually

Q. A 50Hz, 8 pole, 3 phase I.M. has a full load slip of 4%. Its rotor impedance per phase on standstill is 0.01+j0.005 ohms. Then the speed at maximum to

Q. Which of the following operations occur in a vapour refrigeration cycle?