M

Mr. Dubey • 52.30K Points
Coach 

Q. Where a spring with a spring rate that increases with load is desired

(A) Soft springs are used
(B) Non-ferrous springs are used
(C) Elliptical section is preferred
(D) Conical spring are used
Correct : Option (D)

Share

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. Venturi tubes are generally made of

Q. The maximum percentage of carbon in ferrite is

Q. A uniform cylinder of weight W is rolling while slipping on a rough horizontal surface under the influence of a horizontal force. The force of frictio

Q. In centerless grinding, workpiece is supported by

Q. The input to the low pressure feedwater heater is from?

Q. Flexible shafts have rigidity in torsion making them flexible.

Q. In a steam turbine cycle the lowest pressure occurs in

Q. The power factor of a 3 phase induction motor near full load is expected to be around

Q. A liquid mixture contains 30% o-xylene, 60% p-xylene and 10%. m-xylene (all percentages in w/w). Which of the following statements would be true in re

Q. If an air cooled compressor gets over-heated during operation, the probable cause cannot be