M

Mr. Dubey • 52.30K Points
Coach 

Q. The usual clearance provided in hydrodynamic bearing per mm of diameter of shaft is

(A) 1 micron
(B) 10 micron
(C) 0.01 micron
(D) 0.1 micron
Correct : Option (A)

Share

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. On gathering stiffness and loads, the system of equations is given by

Q. A rope of weight 0.5 kg/m hangs from a drum for a height of 6 m. The work done in winding up the rope will be

Q. In counter flow heat exchangers

Q. When the reactive component is small

Q. Hygrometer is used to measure

Q. If h1 = inner film co-efficient and /h2 = outer film co-efficient, then the overall heat transfer co-efficient is

Q. The air gap between the stator and rotor of a 3 phase induction motor ranges from

Q. According to ASTM E709-95 with prod technique, the prods shall be tipped if the open circuit voltage is over:

Q. What is inoculation of cast iron?

Q. The presence of fluorides in drinking water helps in