M

Mr. Dubey • 52.30K Points
Coach 

Q. Gang milling refers to the use of two or more milling cutters mounted on the ____ arbor in a ____ milling set up.

(A) Same, vertical
(B) Same, horizontal
(C) Different, vertical
(D) Different, horizontal
Correct : Option (A)

Share

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. Which of the following is an advantage of using a focused transducer?

Q. In a vibrating system, if the actual damping coefficient is 40 N/m/s and critical damping coefficient is 420 N/m/s, then logarithmic decrement is equa

Q. Which of the following broaches are re-sharpened by grinding at rake faces?

Q. The material commonly used for machine tool bodies is

Q. For I.M. running with 1440rpm with slip of 4% the synchronous speed of rotating magnetic field

Q. For a 7.46 kW, 200 V dc shunt motor with full load efficiency of 85% has armature resistance of 0.25 ohms. Calculate the value of starting resistance

Q. The spots from a car body are removed by

Q. The rate at which entropy is transferred out must the rate at which entropy enters the control volume.

Q. Stefan-Boltzmann law which describes the radiation heat transfer states that, it is proportional to (where, t = temperature in °C T = absolute tem

Q. Air consumption of a four-stroke diesel engine per rated BHP/hr will be