M

Mr. Dubey • 53.40K Points
Coach 

Q. The plastic hinge in a section is caused when

(A) all the fibres at a section reach the yield state
(B) the material at a section reaches plastic state
(C) the extreme fibres at a section reach the yield state
(D) none of the above
  • Correct Answer - Option(A)
  • Views: 444
  • Filed under category Machine Design
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. How many kg of air will contain one kg of oxygen?

Q. To reduce the tube side pressure drop for the same flow rate, the heat exchanger recommended is

Q. Rotary pumps are driven by

Q. According to kinetic theory of heat

Q. A block of weight 20 kg slides with an initial velocity of 2 m sec down an inclined plane on to a spring of stiffness 10 kg/cm. If the co--efficient o

Q. What is the relation between capacitance and input impedance?

Q. For low head and high discharge the hydraulic turbine preferred is

Q. The edges of boiler plates for fullering and caulking are bevelled at an angle of

Q. The first critical speed of an automobile running on a sinusoidal road is calculated by (modeling it as a single degree of freedom system)

Q. 85m, kb = 0.55m C = 80 GN/m2

Question analytics