M

Mr. Dubey • 52.30K Points
Coach 

Q. Which of the following defects occur due to flux employed and electrode coating?

(A) inclusion of slag
(B) inadequate penetration
(C) incomplete fusion
(D) porosity
Correct : Option (A)

Explanation: 
 slag inclusions are one of the main weld defects. if we don’t properly clean the slag from a bead, we run the risk of it becoming part of the weld when we run the next bead. a good welder will generally burn it out on the next pass, but if not, there will be a chunk of slag in the bead which leaves a weak spot. slag inclusions.

Share

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. In retardation type measuring lag the instrument responds after an unspecified dead time lag.

Q. The y-coordinate of the centroid of the area bounded by the x-axis, the line x = 3 and the parabola y = x2 will be

Q. Terminal point temperature differences between fluids in case of a heat exchanger is termed as

Q. For under water movement of a submarine the power is provided by

Q. Decibels are basically measures of

Q. Minimum number of teeth for involute rack and pinion arrangement for pressure angle of 20° is

Q. A block of weight 20 kg slides with an initial velocity of 2 m sec down an inclined plane on to a spring of stiffness 10 kg/cm. If the co--efficient o

Q. Dried, non-aqueous developers are best removed after penetrant testing by:

Q. A rotor which is balanced statically but not dynamically is supported on two bearings L apart and at high speed of the rotor, reaction on the left bea

Q. A cotter joint is used to connect two __________ rods.