M

Mr. Dubey • 52.30K Points
Coach 

Q. Which of the following step/s is/are correct to perform reading operation from an LCD?

(A) low to high pulse at e pin
(B) r/w pin is set high
(C) low to high pulse at e pin & r/w pin is set high
(D) none of the mentioned
Correct : Option (C)

Share

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. Water tube boilers are those in which

Q. A screw will be self locking, if

Q. Volumetric efficiency of supercharged engine is

Q. If air (a non-condensing gas) is present in a condensing vapor stream, it will __________ the condensation rate of vapor.

Q. The most injurious components of automobile exhaust for environment are

Q. Which of the following is unlikely to be the pollutant from a sulphuric acid plant?

Q. A 3-phase slip-ring induction motor has ……………… rotor.

Q. For heavy loads in aircraft bearings the material used with lead to reduce the risk of scizure is

Q. A grinding wheel rotates at 3000 rpm. When power supply is cut off the wheel stops in 5 sec. The number of revolutions made by the wheel before coming

Q. Fuel injector is used for