M

Mr. Dubey • 52.30K Points
Coach 

Q. What steps have to be followed for interfacing a sensor to a microcontroller 8051?

(A) make the appropriate connections with the controller, adc conversion, analyse the results
(B) interface sensor with adc and adc with 8051
(C) interface sensor with the max232, send now to microcontroller, analyse the results
(D) none of the mentioned
Correct : Option (B)

Share

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. Which motor is preferred for Jaw crushers?

Q. Which of the following nutrients are lost in all steps of food engineering (including packaging and freezing)?

Q. The power supplied to domestic consumers is at 220 volts. This represents

Q. Two three phase induction motors A and B are identical in all respects except that motor A has a larger air-gap than motor B. Which motor will have mo

Q. Lead foil is placed behind the films to:

Q. Small DC motors have best speed control by

Q. A plait point is the point on the solubility curve, where the tie line reduces to a point. What is the number of plait point for a ternary system cont

Q. Which of the following are important parts of knuckle joint?

Q. The area under the load curve represents

Q. In which of the following addressing mode, the offset is obtained by adding displacement, with the contents of SI?