M

Mr. Dubey • 52.30K Points
Coach 

Q. According to ASTM E709-95 in using prod technique, prod spacing shall not exceed:

(A) 50 mm
(B) 100 mm
(C) 150 mm
(D) 200 mm
Correct : Option (D)

Share

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. The dimensions of gravitational constant G

Q. Cooling and dehumidification of air is done in summer air conditioning.

Q. The steam pressure in a pass out turbine may be expected to be in the range

Q. A block of wood and a block of metal feel equally cold or equally hot when touched. Then their common temperature is

Q. The draw of cotter need not exceed

Q. Which of the following is not a method used for preparing approximate estimates?

Q. The swaying couple is due to the

Q. The following code will produce dwell for a specified time…

Q. All stresses produced in a belt are

Q. The plastic design of steel structures which is based on the statical method of plastic analysis is