M

Mr. Dubey • 95.57K Points
Coach

Q. A wire brush should be used for pre-cleaning:

  • (A) When grease and oil must be removed
  • (B) Only as a last resort
  • (C) When rust is to be removed
  • (D) When grinding burrs must be removed
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Loading Comments....

Related MCQs

Q. The last four digits of the Opitz classification system are ______

Q. Wheel base of a vehicle is the

Q. The use of coatings on milling cutters will increase the ____ of the tool.

Q. The selection of material for gears depends on

Q. According to Trouton’s rule, the ratio of latent heat of vaporization to the boiling point at 1.013 bar is

Q. A reaction which occurs when a radiation beam of 500 keV is partially absorbed by a test piece would probably be:

Q. The useful life of static capacitor can be expected to be

Q. Which of the following industrial process uses waste as a fuel?

Q. A universal coupling is used to connect two shafts

Q. Which of the following penetrants must be treated with an emulsifier prior to water removal?

Question analytics