M

Mr. Dubey • 52.30K Points
Coach 

Q. Magnetic particle is a non-destructive examination method used for:

(A) Locating surface discontinuities
(B) Near surface discontinuities
(C) Both a and b
(D) Material separation
Correct : Option (C)

Share

Discusssion

Login to discuss.

Loading Comments....

Related MCQs

Q. Mode of heat transfer in which the fluid moves under the influence of changes in fluid pressure produced by external work is called

Q. Which one of the following does not form a part of the fuel supply system for a Diesel engine?

Q. A sphere 15 cm in diameter is covered with 5 cm of insulation (k = 0.057 kcal/m-hr-?C). The inside and outside surface temperature of the insulation a

Q. Hall potential is inversely proportional to magnetic flux density.

Q. When the connected members are very yielding (soft gasket) as compared to the bolt, then the resultant load on the bolt will be equal to the

Q. A key and a shaft are made from the same material. The key is rectangular with a width of D/4 and a height of 3D/16. The shaft is under torsion only.

Q. The usual clearance provided in hydrodynamic bearing per mm of diameter of shaft is

Q. Turbidity in water is due to

Q. During immersion testing of pipe or tubing the incident longitudinal wave angle must be limited to a narrow range. The reason for the upper limit is:

Q. The moment of inertia of a thin ring about an axis perpendicular to plane of ring is