M

Mr. Dubey • 52.49K Points
Coach 

Q. According to ASTM E709-95 in using prods having a spacing of 19 mm (3/4 inches) and above, the magnetizing current shall be:

(A) From 90 to 110 A/25 mm (1 inch)
(B) From 100 to 125 A/25 mm (1 inch)
(C) From 90 to 120 A/ 25 mm (1 inch)
(D) From 100 to 200 A/25 mm (1 inch)
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. All of the following are point defects EXCEPT

Q. The ratio of circumferential stress to longitudinal stress in a thin cylinder subjected to an internal pressure is

Q. is required for preliminary studies of various aspects of a work or project.

Q. The helix angle is very small about 2⁰. The spring is open coiled spring.

Q. Which of the following is measure of stiffness?

Q. Extremely large or small volumes of fluids are generally best routed through the shell side of a shell and tube heat exchanger, because of the

Q. The starting method for a 3-phase squirrel-cage induction motor which is inferior in view of poor starting torque per ampere of line current drawn is?

Q. A couple consists of a force P acting at a point A whose coordinates are (-1,2,4) m and force - F acting at a point whose coordinates are (2,3, -2)m.

Q. Three states of matter are distinguished with repect to molecules by

Q. Elements of pairs held together mechanically is known as

Question analytics