M

Mr. Dubey • 52.77K Points
Coach 

Q. A method of compensating for the ‘dead zone’ or near surface resolution problems is to:

(A) Inspect all areas of the test piece twice to assure repeatability of indications
(B) Re-inspect from the opposite side of the test piece if geometry permits
(C) Re-inspect using a higher energy pulse
(D) Re-inspect using a higher frequency transducer that does not have a ‘dead
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. The torque acting on a system is zero. Which of the following will be conserved?

Q. When two non-intersecting and non-coplanar shafts are connected by gears, the arrangement is known as

Q. In which case value engineering may not be relevant?

Q. The pitch of 24 mm diameter metric threads would be

Q. What is the reason for the limitation of depth below 6mm in ECI?

Q. If you were on one side of a wireframe cube looking toward a solid sphere on the other side of the cube, you would see

Q. The critical speed of a shaft with a disc supported in between is equal to the natural frequency of the system in

Q. Which of the following is a disadvantage of immersion test units?

Q. The top ring nearest to the piston crown is known as

Q. Which of the following represents the output of Hall Effect transducer?

Question analytics