Processing math: 100%

M

Mr. Dubey • 53.50K Points
Coach 

Q. The purpose of adding a wetting agent to an immersion bath is:

(A) To make sure the bath is wet
(B) To reduce corrosive properties of the bath
(C) To eliminate air bubbles in the bath
(D) To prevent rust
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. An automobile weighing 2800 lb and travelling at 30 miles/hr, hits a depression in the road which has a radius of curvature of 50 ft. What is the tota

Q. For a 7.6 cm (3 inches) diameter bar how much current is needed to magnetize the bar for the detection of longitudinal discontinuities:

Q. Lancashire boiler has _____ internal flue tubes.

Q. During hardening soft spots can be avoided by

Q. The value overlap in case of four stroke petrol engine is approximately

Q. In a break even chart, abscissa represents

Q. The compression ratio in case of a gas turbine is of the order of

Q. According to ASTM E709-95 the UV light shall be centred on (1 Å = 10-10m):

Q. Which of the following is the major source of flyash emission?

Q. The maximum efficiency of spiral gears is (where θ = Shaft angle and φ = Friction angle)

Question analytics