A possible result of failing to use a stop bath during manual development is:

M

Mr. Dubey • 52.30K Points
Coach

Q. A possible result of failing to use a stop bath during manual development is:

(A) Streaking of the film

(B) Underdevelopment of the film

(C) Contamination of the developer solution

(D) Developer solution drag-out

Correct : Option (A)

Share

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. A machine requires an effort of 10 kg to lift a load of 250 kg and an effort of 13 kg for a load of 400 kg. The effort required to lift a load of 500

Q. For 3phase I.M,The synchronous speed of rotating magnetic field is 1000 rpm,speed of rotor is 960 rpm ,then slip is

Q. Synthetic curve pass through defined data points and thus can be represented by

Q. In the following geometric modelling techniques. which cannot be used for finite element analysis:

Q. frequency( fr) of induced emf in rotor of I.M. is given by --

Q. In case of biaxial stress system when a member is subjected to tensile stresses in two perpendicular directions the maximum shear stress in case of mi

Q. Which of the following developers is applied by spray only?

Q. Power is produced when the working fluid does some work on the?

Q. The amount of heat absorbed by a system at lower temperature is

Q. When inspecting a long bar with a longitudinal wave from one end, a series of additional echoes are seen immediately after the bottom surface reflecti