M

Mr. Dubey • 52.74K Points
Coach 

Q. Which of the following is a likely effect of a rough test piece surface?

(A) An improved ultrasonic signal to noise ratio
(B) A more penetrating sound beam
(C) Loss of discontinuity signal amplitude
(D) Higher test reliability
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. A steam power plant working on Rankine cycle produces steam in the boiler at a rate of 100 kg/s with enthalpy of 3280 kJ/kg from water whose total hea

Q. The concept of overall coefficient of heat transfer is used in heat transfer problems of

Q. After steam bubbles break the water surface, they carry water droplets this is called as ________

Q. The matrix representation for scaling in homogeneous coordinates is

Q. What are the two most important properties in determining the penetrating ability of a penetrant?

Q. Batch tray dryers suffers from the disadvantage of

Q. In a Diesel engine the duration between the time of injection and the time of ignition is called

Q. If air resistance is neglected, at the mid-point of its swing, the acceleration of the bob of a simple pendulum along its path is always

Q. In which case value engineering may not be relevant?

Q. In a cam drive with uniform velocity follower, the sharp corners of the displacement diagram are rounded off at the beginning and at the end of each s

Question analytics