R

Ram Sharma • 193.86K Points
Coach 

Q. Width and depth of grooves in the tube sheet holes normally are __________ inch respectively.

(A) 1/8 and 1/64
(B) 1/64 and 1/8
(C) 1/2 and 8
(D) 1/2 and 5
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. Maximum carbon content in any variety of steel can be upto 1.3%. Steel containing 0.4% Carbon is not used for making

Q. The thermal efficiency of a reversible heat engine operating between two given thermal reservoirs is 0.4. The device is used either as a refrigerator

Q. An air-water vapour mixture has a dry bulb temperature of 60°C and a dew point temperature of 40°C. The total pressure is 101.3 kPa and the vapour p

Q. _________ test determines the yield strength, Young's modulus of elasticity, percentage reduction in area & percentage elongation of a material.

Q. Main constituents of Portland cement are calcium aluminate and

Q. Thermal wells used in temperature measurements should have

Q. Which law is followed by the velocity distribution in the turbulent boundary layer?

Q. Interstage coolers are provided in a multistage compressor to

Q. The reason for excessive clinker formation in gas producers is the

Q. Road grade bitumen is produced from vacuum residue by its

Question analytics