M

Mr. Dubey • 52.30K Points
Coach 

Q. The usual clearance provided in hydrodynamic bearing per mm of diameter of shaft is

(A) 0.01 micron
(B) 0.1 micron
(C) 1 micron
(D) 10 microns
Correct : Option (C)

Share

Discusssion

Login to discuss.

Loading Comments....

Related MCQs

Q. The diameter of the small size information board is?

Q. Lowest melting point may be expected for

Q. A 8pole ,3 phase 50Hz I.M is running with 731.25 rpm. The slip of I.M is

Q. In the geysers steam is continuously vented through fissures in the ground. These vents are called

Q. Which of the following metal forming processes performs squeezing out of material through a hole?

Q. At what percentage (by volume) of alcohol composition, it forms an azeotrope with water?

Q. Which is the variable stress

Q. In a packed tower, the value of HETP equals HTUOG, when the equilibrium and the operating lines are (where, HETP = height equivalent to a theoretical

Q. Which of the following is the process in the RP cycle?

Q. What is the actual turbine inlet temperature in Rankine cycle?