M

Mr. Dubey • 60.51K Points
Coach 

Q. The diameter of knuckle pin in a knuckle joint is usually taken as (where d = Diameter of the rod)

(A) 0.5 d
(B) 0.8 d
(C) d
(D) 1.2 d
  • Correct Answer - Option(C)
  • Views: 491
  • Filed under category Machine Design
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. Wooden poles for supporting transmission lines are used for voltages upto

Q. is required for preliminary studies of various aspects of a work or project.

Q. The acceleration of the reciprocating roller follower when it has contact with the straight flanks of the tangent cam, is given by

Q. Which of the following is an advantage of using a focused transducer?

Q. Which of the following material can be used for the filaments in incandescent lamps?

Q. The work done in sliding a block of weight of 50 kg up a plane inclined at an angle of 30o to the horizontal so that the block is lifted th

Q. The rough value of diffusion co-efficient of water vapor into air at 25°C may be about __________ cm2/sec.

Q. The intensifying effect of lead screens is mainly caused by:

Q. In an actual SI engine the pumping loss with respect to speed

Q. In inertia friction welding energy of welding machine is used.

Question analytics