M

Mr. Dubey • 52.70K Points
Coach 

Q. In regenerative type heat exchanger, heat transfer takes place by

(A) direct mixing of hot and cold fluids
(B) a complete separation between hot and cold fluids
(C) flow of hot and cold fluids alternately over a surface
(D) indirect tr
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. If shearing stress in nut is half the tensile stress in a bolt, then nut length should be equal to

Q. In a mechanism, the fixed instantaneous centers are those centers which

Q. According to Kirchoff’s law, the ratio of emissive power to absorptivity for all bodies is equal to the emissive power of a

Q. In a cyclic heat engine operating between a source temperature of 600°C & a sink temperature of 20°C, the least rate of heat rejection per

Q. Which of the following disadvantages occurs due to low power factor?

Q. Which of the following exists in a p-V diagram for water?

Q. A 25kW, 3 phase I.M. is running with 6% slip. Its rotor copper losses are ____ if frictional losses are 850W.

Q. A fan is being used under certain conditions. If the fan speed is doubled the power requirement will be

Q. Which of the following is not correct about fixture?

Q. For a shaft diameter of 200 mm, the number of bolts in a marine flange coupling should be

Question analytics