R

Ranjeet • 34.60K Points
Instructor I 

Q. The following type of layout is preferred to manufacture a standard product in large quantity

(A) Product layout
(B) Process layout
(C) Fixed-position layout
(D) GT layout
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. Magnetic particle testing is most likely to find subsurface discontinuities in:

Q. In a Diesel engine, during combustion the pressure may increase at a range of

Q. The resilience of a bolt may be increased by

Q. Shrinkage allowance does not depend on which of the following factor?

Q. For a compressible, ideal gas, mass flow rate depends on parameters such as flow area, pressure, temperature, properties of the gas, and

Q. In involute gears, the pressure angle is

Q. The presence of which of the following material in water is not considered to be dangerous?

Q. In which zone does the amplitude of an indication from a given discontinuity diminish exponentially as the distance increases?

Q. Large sections usually have a somewhat lower permissible stress than small sections. This is due to

Q. What does regenerative air preheater consists of?

Question analytics