V

Vijay Sangwan • 28.62K Points
Instructor II 

Q. Which of the following is used as base material in Stereolithography (SLA) process?

(A) Thermoplastics , Metals powders
(B) Thermoplastics , Eutectic metals.
(C) Titanium alloys
(D) Photopolymer
Correct : Option (D)

Share

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. A period of reduced economic activity is called

Q. A motor weighing 2000 kg is to be lifted by wrought iron eye bolt, screwed into the frame. Clioose-single bolt out of the following

Q. A grinding wheel is rotating at 3000 rpm. When the switch is turned off the wheel stops in 10 seconds. The uniform deceleration of the wheel was

Q. Wing screws are used where

Q. In a reheat Rankine cycle steam with enthalpy of 3300 kJ/kg is expanded in h.p turbine to a state where enthalpy is 2650 kJ/kg. The steam is further e

Q. A pure substance which exists in a single phase has independent variables.

Q. Which principle is used in the three master guideways and probe location?

Q. When a gas is pushed through a pipe, the gaseous molecules are by the pipe’s walls

Q. A 3-phase ,400 V, 4-pole induction motor is fed from a 3-phase, 400V, 50 Hz supply and runs at 1440 rpm. The frequency of rotor emf is

Q. The ratio of the useful heat drop to the isentropic heat drop is called ____________