A

Admin • 36.96K Points
Coach 

Q. he depth that the tool is plunged into the surface is called as

(A) feed
(B) depth of cut
(C) depth of tool
(D) working depth
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. DBA = DAB, in case of

Q. other than Steam stop valve in the boiler which is the other similar type of valve used?

Q. Which defect is caused due to the conversion of moisture to steam because of the heat of molten metal?

Q. The relative speed between stator flux and rotor is equal to

Q. If the structure of a sample consists of pearlite, cementite and free carbon, the sample may be

Q. The voltage of a 2 wire de system is raised from 200 V to 400 V. For the same power transmitted over the same distance and for the same power loss, th

Q. For reciprocating air compressor the law of compression desired is isothermal and that may be possible by

Q. The tendency of a body to resist change from rest or motion is known as

Q. A 3.2 m diameter balloon is filled with Helium. The total weight of balloon, gas and pay load is 10 kg kg. In an isothermal atmosphere having conditio

Q. If the contact breaker gap is small, it results in

Question analytics