R

Ranjeet • 34.60K Points
Instructor I 

Q. The is used to create a surface using curves that form closed boundaries.

(A) ruled Surface
(B) plane Surface
(C) coons patch
(D) surface of Revolution
Correct : Option (C)

Share

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. In steam and gas turbines, rolling contact bearings are used.

Q. Due to which of the following reasons the Carnot cycle cannot be realised in actual practice?

Q. Why might steel parts have a greater tendency towards rusting after penetrant testing?

Q. In which type of operation, motion of cutting tool is translating?

Q. Which type of gears are preferred for low noise applications?

Q. On moving the feed line (q-line) from saturated liquid feed (vertical position) to saturated vapor feed (horizontal feed), if the slope of both the op

Q. Plow bolts are widely used in

Q. A stone weighing 20 N is whirling in a vertical circle at the extremity of a string 100 cm long. The tension in the string will be zero

Q. When adsorption hysteresis is observed, the desorption equilibrium pressure is __________ that obtained by adsorption.

Q. Induced draft fan for a boiler is always located