M

Mr. Dubey • 52.30K Points
Coach 

Q. Which is the primary cost for degradation of error performance?

(A) loss in signal to noise ratio
(B) signal distortion
(C) signal distortion & loss in signal to noise ratio
(D) none of the mentioned
Correct : Option (C)

Explanation: 
 there are two primary causes for the degradation of error performance.

Share

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. The motor commonly used in computers and digital systems is

Q. In transistor oscillators, the requirement of a negative resistance device is satisfied using a varactor diode.

Q. In conventional amplifiers, a flat gain response is achieved at the cost of reduced gain. But this drawback can be overcome by using:

Q. In a stable control system saturation can cause which of the following ?

Q. Error detector:

Q. A separately excited generator as compared to a self-excited generator

Q. Expression for over all noise figure of a mismatched amplifier is:

Q. The breakdown of insulation of the cable can be avoided economically by the use of

Q. One condition to be satisfied in an oscillator circuit so that stable oscillations are produced is:

Q. A.C. servomotor resembles