M

Mr. Dubey • 53.11K Points
Coach 

Q. An ideal traction system should have

(A) easy speed control
(B) high starting tractive effort
(C) equipment capable of with standing large temporary loads
(D) all of the above
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Loading Comments....

Related MCQs

Q. A common-collector transistor circuit is often used

Q. Microwave tubes are power sources themselves at higher frequencies and can be used independently without any other devices.

Q. An A.C. voltage is impressed across a pure resistance of 3.5 ohms in parallel with a pure inductance of impedance of 3.5 ohms,

Q. A differential amplifier is invariably used in the i/p stage of all OP-AMPs.This is dome basically to provide the OP-AMPs with a very high

Q. In a control system integral error compensation steady state error

Q. The number of armature parallel paths in a two-pole D.C. generator having duplex lap winding is

Q. The e.m.f. induced in the armature of a shunt generator is 600 V. The armature resistance is 0.1 ohm. If the armature current is 200 A, the terminal v

Q. When voltage feedback (negative) is applied to an amplifier, its input impedance _________.

Q. Which of the following should be done to make an unstable system stable ?

Q. An essential requirement for the BARITT diode is that the intermediate drift region be completely filled to cause the punch through to occur.

Question analytics