M

Mr. Dubey • 52.30K Points
Coach 

Q. The selection of control gear for a particular application is based on the consideration of

(A) duty
(B) starting torque
(C) limitations on starting current
(D) all of the above.
Correct : Option (D)

Share

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. In ........the speed can be varied by changing the position of brushes

Q. If the standing wave ratio for a transmission line is 1.4, then the reflection coefficient for the line is:

Q. The cables, the location of fault is usually found out by comparing

Q. 1 MICROWAVE PASSIVE COMPONENTS: DIRECTIONAL COUPLER, POWER DIVIDER, MAGIC TEE ATTENUATOR, RESONATOR

Q. A certain cable has an insulation of relative permittivity 4. If the insulation is replaced by one of relative permittivity 2, the capacitance of the

Q. The rapid wear of brushes takes place due to

Q. Cables for 220 kV lines are invariably

Q. The voltage gain of an emitter follower is ______

Q. A pure inductance connected across 250 V, 50 Hz supply consumes 100 W. This consumption can be attributed to

Q. A is a device that converts a guided electromagnetic wave on a transmission line into a plane wave propagating in free space.