R

Ram Sharma • 193.86K Points
Coach 

Q. The primary purpose of the UCS (User Coordinate System) is?

(A) Helps a user to calculate the area of an object.
(B) To determine angles for isometric projections.
(C) Allows a user to select the desired type of drawing units.
(D) Allows a user to draw on a specified 2D Plane in 3D space
  • Correct Answer - Option(D)
  • Views: 659
  • Filed under category AutoCAD (CAD)
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. Silicon steel is widely used in

Q. The diameter of knuckle pin in a knuckle joint is usually taken as (where d = Diameter of the rod)

Q. Which of the following may cause magnetic particle test indications?

Q. Which of the following has the minimum absorptivity?

Q. Why is wet compression not preferred?

Q. Compression ratio of LC. Engines is

Q. Heating wet steam at constant temperature is heating it at constant

Q. defects in castings cannot be identified easily.

Q. ____ sensors are used to indicate presence or absence of hot objects

Q. When load is connected to three phase induction motor is increased, then its slip

Question analytics