To control the type of surface created using the Smooth surface option of the PEDIT command, use the

R

Ram Sharma • 193.84K Points
Coach

Q. To control the type of surface created using the Smooth surface option of the PEDIT command, use the

(A) SURFTAB1 system variable

(B) SURFTAB2 system variable

(C) SURFTYPE system variable.

(D) EDGESURF command.

Correct : Option (C)

Share

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. Squeeze casting method was developed in which country?

Q. Hydrogen cannot be liquefied at room temperature because

Q. Which of the following is generally not used as a thermocouple material?

Q. A Babbitt is

Q. Statement 1: Flank angle of symmetrical thread is known as thread’s half-angle. Statement 2: It is measured parallel to the axis of a thread.

Q. The insulators for overhead lines are generally made of

Q. The maximum shear stress theory is used for

Q. A body is vibrating with simple harmonic motion of aplitude 5 cm frequency 10 vibrations per second. The maximum value of velocity in cm/s will be

Q. When geothermal energy is available in the form of saline water, power is developed using

Q. The frictional torque transmitted in a flat pivot bearing, considering uniform wear, is (where μ = Coefficient of friction, W = Load over the beari