M

Mr. Dubey • 52.30K Points
Coach 

Q. Which of the following cannot tolerate misalignment?

(A) angular contact bearing
(B) cylinder roller bearing
(C) thrust ball bearings
(D) all of the listed
Correct : Option (D)

Explanation: 
 all of these require précised alignment.

Share

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. When steam is transported dryness fraction _________

Q. In order to reverse the direction of rotation of a 3-phase induction motor

Q. The pin supporting the exhaust iever of an internal combustion engine is subjected to a shear load of 400 kg/sq-cm the diameter of the pin should be

Q. Ionisation gauge is used to measure pressures

Q. Where and when was the word Mechatronics invented?

Q. The source of energy for satellite is

Q. Proofing allows the required chemical reactions to take place to allow enough CO2 to leave the container and make the dough to fill the container so a

Q. Brass in an alloy of

Q. 45 N/mm2. The connecting rod length between centres is 1.2 m and the cylinder bore is 0.5 m. If the engine runs at 250 r.p.m. and if the effect of pis

Q. Fouling factor for a heat exchanger is given by (where, U1 = heat transfer co-efficient of dirty surface U2 = heat transfer co-efficient of clean surf