M

Mr. Dubey • 55.48K Points
Coach 

Q. Which of the statement is correct with regard to the bandwidth of the control loop system:

(A) in systems where the low frequency magnitude in 0 db on the bode diagram, the bandwidth is measured at the -3 db frequency
(B) the bandwidth is the measurement of the accuracy of the closed loop system
(C) the stability is proportional to the bandwidth
(D) the system with larger bandwidth provides slower step response and lower fidelity ramp response
Share
Explanation by: Mr. Dubey 
 bandwidth is the frequency measured at the gain of 3db and for the good control system the value of the bandwidth must be large but the large value of the bandwidth increses the noise in the system.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Be the first to start discuss.

Related MCQs

Q. In series motor which of the following methods can be used for changing the flux per pole?

Q. The transfer function of a LTI system is given as 1/(s+1). What is the steady-state value of the unit-impulse response?

Q. Which of the following device should be used as a switch in a low power switched mode power supply (SMPS)?

Q. A house served by a 220V supply light, is protected by a 9-Ampere fuse. The maximum number of 60 W bulbs in parallel that can be turned on is

Q. Brushes of D.C. machines are made of

Q. PI controller:

Q. When current feedback (negative) is applied to an amplifier, its output impedance _________

Q. Capacitors for power factor correction are rated in

Q. In over compounded generator, full load terminal voltage is

Q. D.C. generators are connected to the busbars or disconnected from them only under the floating condition

Question analytics