M

Mr. Dubey • 52.30K Points
Coach 

Q. The transfer function technique is considered as inadequate under which of the following conditions?

(A) systems having complexities and non- linearity’s
(B) systems having stability problems
(C) systems having multiple input disturbances
(D) all of the mentioned
Correct : Option (D)

Explanation: 
 transfer function is the ratio of laplace output to the laplace input with the zero initial conditions and is considered inadequate due to complexity, stability problems and multiple input disturbances.

Share

Discusssion

Login to discuss.

Loading Comments....

Related MCQs

Q. Motor preferred for kiln drives is usually

Q. Rotor of the motor is usually supported on........... bearings

Q. In open loop system

Q. When two D.C. generators are running in parallel an equilizer bar is used

Q. Fleming's right-hand rule regarding direction of induced e.m.f., correlates

Q. An A.C. voltage is impressed across a pure resistance of 3.5 ohms in parallel with a pure inductance of impedance of 3.5 ohms,

Q. The transfer function of a LTI system is given as 1/(s+1). What is the steady-state value of the unit-impulse response?

Q. motor is a constant speed motor.

Q. A current of 16 amperes divides between two branches in parallel of resistances 8 ohms and 12 ohms respectively. The current in each branch is

Q. In a Gunn diode oscillator, the electron drift velocity was found to be 107 cm/second and the effective length is 20 microns, then the intrinsic frequ