Computer Architecture and Organization MCQs | Page - 18

 four message types are: confirmable

 four coap methods: get

 ipx (internetwork packet exchange) is the netware network layer 3 protocol used for transferring information on lans that use novell’s netware.

 netware link services protocol (nlsp) provides link-state routing.

 the “debug ip igrp events” is used to display a short summary of igrp routing information. you can append an ip address onto either console’s command-line to see only the igrp updates from a neighbor. the command will only give a short summary and hence won’t flood the command line.

 it isolates network 10.0.0.0 and

 the following commands setup the sub interfaces to allow for two types of encapsulation:interface ethernet 0.1 ipx encapsulation novell-ether ipx network 9e interface ethernet0.2 ipx encapsulation sap ipx network 6c.

 it enables load sharing on 2 paths if the paths are equal metric paths. the default is 1 path and the maximum is 512 paths. the value must always be greater than 1 and must be a natural number.

 to assign multiple network numbers, you usually use sub interfaces. a sample configuration follows: ipxethernet

 gns is novell’s protocol to get nearest server. if there is a server on the local network,that server will respond. if there isn’t, the cisco router has to be configured to forward thegns sap.